Neue Produkte
Neue Produkte
-
Black Brant III - Estes
16,50 € -
53F32WH-12A – Reload 29 mm CTI
42,50 € -
654J316PI-17A - 38 mm CTI nachladen
134,50 € -
56F120VM-14A - Reload 29 mm CTI
40,99 € -
53F70WT-14A - Reload 24 mm CTI
32,95 €
UDDT - Universal Delay Drilling Tool - Aerotech
Set the delay of your Aerotech reload
The Universal Delay Drilling Tool is used to shorten the delay time of Aerotech RMS-EZ reloads. By adjusting the delay time you can get the parachute ejected at the perfect flight time you calculated.
Sichere Zahlungen: Kreditkarte, PayPal, Banküberweisung
Schneller Versand – Wir versenden weltweit
Einfache Rückgabe von Kits und Zubehör
Adjust the delay as you need!
Aerotech DMS high power single-use motors have a forward closure with the delay element already installed. The delay time is set to the maximum value allowed for each motor, therefore you need to shorten it depending on your rocket requirement.
The UDDT allows you to take 2, 4, 6 or 8 seconds out of the delay by drilling a hole into it. The tool consists in a cylindrical body with a different depth receptacle on both sides, plus an handle with a drilling bit and a spacer. Depending the side you put the forward closure against, it takes 4 or 8 second off the delay, but 2 seconds can be subtracted from this time using the included spacer. In this way you can shorten the delay of 2, 4, 6 and 8 seconds.
When to use this tool?
The UDDT is required to adjust the delay of any Aerotech DMS 38 mm motor
Set the delay of your Aerotech reload
The Universal Delay Drilling Tool is used to shorten the delay time of Aerotech RMS-EZ reloads. By adjusting the delay time you can get the parachute ejected at the perfect flight time you calculated.